On 12/16/15 20:54, Kostya Berger wrote: > Well, this seems to be either hardware or software (driver code) bug. > After `usbconfig -d ugen1.4 reset` webcamd restarting sometimes creates the device /dev/video0 -- sometimes,, but not every time. More often than not it doesn't. So there's no method seen in this behaviour so far. I wonder how I could debug this. > > Sent from Yahoo Mail on Android > > On Wed, Dec 16, 2015 at 1:22, Kostya Berger<bergerkos_at_yahoo.co.uk> wrote: Ok, I failed to make it clear enough: the module is loaded on boot. This was what was actually meant by the expression "when the system starts". By contrast, loading on demand is... well, loading "on demand". These are two ways of starting a program, "on demand", as opposite to "when the system starts". Please, correct me if I'm wrong here.Yet the situation is as I described. That's what I'm actually reporting. Just now I've done a reboot, and here we go again: all modules loaded, /dev/cuse persent, the message telling me "webcam is already running on ugen1.4.0" (my web-camera) -- and NO /dev/video0. > > Though it hits me now, there are 3 devices /dev/usb/1.4.*. Maybe 1.4.0 is not the correct one? > Sent from Yahoo Mail on Android > Can you check: ps auxw |grep webcamd Are there any webcamd coredumps? What does usbconfig say? --HPSReceived on Thu Dec 17 2015 - 07:12:04 UTC
This archive was generated by hypermail 2.4.0 : Wed May 19 2021 - 11:41:01 UTC